Flange gate valve replaceable stem F5


Typ 2000

Ciśnienie robocze PN10/PN16

Żeliwo sferoidalne GJS 500-7 lub

Żeliwo szare GJL 250

Średnice DN50 – DN150

Temp. max. 40°C – dla wody

Temp. max. 70°C – dla innych płynów

Category:

Description

Flanged wedge gate valve, soft sealing with replaceable stem sealing, made of ductile iron or grey cast iron in long housing and covered with epoxy coating for excellent anti-corrosion protection. Used mainly in water supply systems, waste water systems and systems for other chemically inert liquids (applies to DN40 and DN50).

APPROVAL

National Institute of Hygiene Warsaw

TECHNICAL DATA

Flanged connection according to PN-EN 1092-2.
Installation length according to PN-EN 558+A1.
Maximum closing torque MOT=1xDN [Nm].
Requirements and tests according to PN-EN 1074 – 1 and 2
Industrial valves PN-EN 1171

CONSTRUCTIONAL FEATURES:

  • Full, smooth and cavity-free passage.
  • The valve stem sealing may be replaced under full pressure in any position of the wedge.
  • A brass screw of the gate valve stem seal (replaceable) protected against unscrewing by a stainless steel spring ring, located inside the cover under the top seal.
  • Stainless steel non-lifting stem with cold rolled thread, with no notches in the sealing zone, making it possible to work with o-rings in the screw.
  • Triple sealing system of the stem: top seal, set of 5 o-rings (4 o-rings inside and outside the screw), bottom seal, lip seal.
  • Bottom washer made of polyamide PA6, which is a sliding washer protecting low-friction bearing of the spindle.
  • Body and cover made of ductile cast iron EN-GJS 500-7 or grey cast iron EN-GJL 250.
  • Wedge made of ductile cast iron, vulcanised inside and outside with EPDM or NBR rubber, hardness 70±5°Sh. guided in guides being an integral part of the gate body.
  • Wedge suspension nut on the stem – non-replaceable, made of brass, hot-dipped in the gate valve wedge, eliminating the possibility of wedge vibration.
  • Static seals made of EPDM rubber, dynamic seals made of NBR rubber.
  • Screws connecting the cover with the body – blind threads, fully protected against corrosion with paraffin-wax compound.
  • Internal and external protection against corrosion with epoxy powder paint RAL 5005, thickness min. 250um and puncture resistance 3kV

Download catalogue card
“Zasuwa klinowa kołnierzowa PN16 szereg 15 - 2000” PDF, 431 KB


Download declaration of performance
“Zasuwy klinowe kołnierzowe” PDF, 102 KB